Eco Grout: Pinhole Filler for Polished Concrete
Eco Grout: Pinhole Filler for Polished Concrete
Small pinholes and air pockets can appear as concrete is ground and polished. Eco Grout is a water-based acrylic binder used with concrete dust to make a paste that fills these small surface imperfections. It helps create a more even surface for the next polishing stage.
Help create a smoother polished concrete finish
Fills small surface voids: Helps fill pinholes and air pockets exposed during grinding.
Blends with the concrete: Mixes with concrete dust from the floor to create a closer colour match.
Used during polishing: Apply by trowel or use the grind-in method as part of the polishing process.
Water-based and virtually odourless: Product information describes it as water-based, virtually odourless and emitting zero toxic VOCs.
Where to use it
Use Eco Grout on concrete during grinding and polishing to fill small pinholes, pores and air pockets. It is a specialist concrete-polishing product; it is not intended as a general-purpose tile grout or structural crack repair.
Product details
| Feature | Details |
|---|---|
| Product type | Water-based acrylic concrete pore filler |
| Intended use | Filling pinholes and small voids during concrete polishing |
| Formulation | Concentrate; dilute 1 part Eco Grout with 1 part water |
| Application methods | Mix with concrete dust and trowel over the surface, or grind in with concrete dust |
| Approximate coverage | 5–7 m²/L of mixed solution |
| Drying time | Approximately 20 minutes at 25°C for trowel application |
| Temperature limit | Do not apply when ambient or floor temperature is above 30°C |
| Appearance | Milky white liquid; dries clear when combined with concrete dust |
| Odour and VOCs | Virtually odourless; zero VOCs |
| Shelf life and storage | 2 years; store in plastic containers at 5–35°C |
How to apply
Make sure the concrete is clean and free from grease, oil, curing agents and other contaminants. Do not apply above 30°C.
Dilute Eco Grout with clean water at a 1:1 ratio.
Trowel method: Mix the diluted solution with concrete dust to make a paste. Trowel it over the surface to fill the pinholes. Allow it to dry, then grind off the excess with 120-grit diamond tooling.
Grind-in method: Apply the diluted solution to the surface and grind it in with concrete dust using 120-grit diamond tooling at low speed. Keep the surface wet while grinding.
Continue with the next concrete polishing stage according to your system and the product instructions.
Drying and coverage can vary with site conditions and the concrete. Read the current product data sheet and Safety Data Sheet before use.
Use Eco Grout during polishing to fill small concrete pores and prepare the surface for a smoother finish.

















