top of page
Potassium silicate concrete hardener for mould resistance

Eco Densi Shield Potassium: Concrete Hardener and Densifier

Eco Densi Shield Potassium: Concrete Hardener and Densifier

Strengthen suitable concrete surfaces with Eco Densi Shield Potassium, a penetrating potassium silicate treatment. It reacts within the concrete to help harden the surface, reduce dusting and improve resistance to everyday wear. Unlike a film-forming coating, it allows moisture vapour to pass through the concrete.

 

Help strengthen and protect concrete

  • Hardens the concrete surface: Penetrates and reacts within the concrete.

  • Helps reduce dusting and wear: Designed to improve surface durability in high-traffic areas.

  • For concrete polishing: Can be used during concrete grinding and polishing.

  • Suitable for exposed aggregate: The product page lists exposed aggregate surfaces among its uses.

  • Water-based and non-flammable: Product information describes the formula as water-based, odour-free and non-flammable.

 

Where to use it

Eco Densi Shield Potassium is suitable for concrete floors, including polished concrete, exposed aggregate, garages, walkways and other high-traffic areas. Concrete must be clean, mechanically prepared and absorbent enough for the treatment to penetrate.

 

The product instructions call for a moisture test and mechanical preparation. Homeowners without concrete-preparation equipment may prefer to use a concrete professional.

 

Product details

FeatureDetails
Product typePotassium silicate concrete hardener and densifier
Suitable surfacesConcrete floors and exposed aggregate
FinishPenetrating treatment; maintains vapour permeability
ApplicationReady to use; apply with a low-pressure sprayer, pump pack, brush or roller
Approximate coverage5–20 m²/L, depending on porosity and application
Second coatApply within 20 minutes, or before the first coat dries
Surface dry time2–8 hours at 25°C
Light foot traffic6–12 hours at 25°C
Vehicle traffic24 hours at 25°C
Application temperature10–30°C
Rain protectionAvoid application if rain is expected within 24 hours
Moisture testProduct instructions specify concrete moisture below 4%
StorageStore at 5–35°C

 

How to apply

  1. Remove oil, grease, dirt, old coatings and curing compounds. Mechanically prepare the concrete as directed.

  2. Test absorbency by sprinkling water on the surface. If the water beads instead of soaking in, further preparation may be needed.

  3. Shake the container and apply an even coat with a low-pressure sprayer, pump pack, brush or roller.

  4. If a second coat is needed, apply it within 20 minutes, while the first coat is still wet. Avoid pooling.

  5. Protect the treated area from rain for 24 hours. At 25°C, allow 6–12 hours before light foot traffic and 24 hours before vehicles.

 

Coverage and drying times vary with surface porosity and site conditions. Check the current product data sheet and Safety Data Sheet before use.

 

Help harden and reduce dusting on suitable concrete with Eco Densi Shield Potassium.

$190.50Price
Quantity

HOW MUCH WILL YOU NEED? 

RESULTS

Total Area:

Litres Needed:

Related Products

bottom of page